PART THREE: building the handle Step 50 View fullsize View fullsize Step 51 View fullsize View fullsize Step 53 View fullsize View fullsize Step 54 View fullsize View fullsize Step 55 View fullsize View fullsize View fullsize Step 56 View fullsize View fullsize View fullsize Step 57 View fullsize View fullsize Step 58 View fullsize View fullsize Step 59 View fullsize View fullsize Step 60 View fullsize View fullsize Step 61 View fullsize View fullsize This assembly should be fit onto the axle so that the clapper inside the bell moves lengthwise to the bricks you just placed, not the sideways. In the photo above, since the ends face north/south, the clapper inside the bell would swing front/back and not side/side. If it’s not right, simply pull your brick assembly up and rotate it 90 degrees, then press it back down. Step 62 View fullsize View fullsize Step 63 View fullsize View fullsize Step 64 View fullsize View fullsize Step 65 View fullsize View fullsize Step 66 View fullsize View fullsize Step 67 View fullsize View fullsize Step 68 View fullsize View fullsize Step 69 View fullsize Step 70 View fullsize View fullsize View fullsize Step 71 View fullsize View fullsize Step 72 View fullsize View fullsize Step 73 View fullsize View fullsize Step 74 View fullsize View fullsize View fullsize Step 75 View fullsize View fullsize Step 76 View fullsize View fullsize Step 77 View fullsize View fullsize You’re done!You can pick up the bell by the handle, but it’s not recommended that you “play” it horizontally, as the casting is heavy and the swinging motion could cause the handle to break off. It is primarily a display piece.